Written on 

Designing a flower stand for 3D printing

3d_design 3d_printing fusion360

Why not have a little fun arranging flowers, yes? I mean, look at it, hardly presentable:

pre shot

But with a rather simple model in Fusion 360 (interactive model):

[Right here should have been an interactive 3D model.]

They look much more presentable:

glamour shot

The design as well as the STL file are freely available under CC – BY NC SA license1. Just beware that since this was an early model, it’s of rather crappy quality.

If I had to print it again, I’d make the walls somewhat thicker, and would perhaps connect the tubes with some ribs, so they wouldn’t move.

  1. The non-commercial bit because I don’t want to get into hot water with Autodesk since my license is the free hobbyist one. ↩